I knew from the minute I laid eyes on it that it would become our kitchen sink and that I would be building a custom kitchen sink base for it! Never mind that it had been sitting in a shed for god knows how long and it had, in fact, been filled to the brim with a mouse nest and had probably raised hundreds (if not thousands) of rodents for decades and was, in fact, totally covered in the resulting excretions. Nope, none of that bothered me! I took one look at this sink and my heart soared. It was perfect! I gathered my materials for building the kitchen sink base.
Step 1My materials all came out of the barn or were scraps from the renovation and, amazingly, the drain was in perfect condition – the only thing we had to purchase was the faucet for $70 at our local fleet store. All of my materials were leftovers in the barn and had been sitting there for a very long time. I knew I wanted to wrap the whole outside of the sink with something very big so I headed to my secret stash of amazing barn wood that I’ve been gathering and pulled out the biggest thing I had: a rough-sawn, ancient, 2×10!
Step 2It was a really basic piece that I had in mind. Four 4×4 legs, 2x4s laid across the top of them for support, and then the entire thing clad with barn wood. First thing I did was get the most accurate measurements of the sink that I could, which was much easier said then done – no part of this sink is flat or square on the bottom side. From there, I knew how long each of my 2x4s needed to be cut to fit totally under the bottom of the sink. From there I also knew exactly how tall the 4×4 legs had to be so I got to cutting. I screwed the whole thing together with my impact driver and 3″ screws (that sink is HEAVY – I needed to make this kitchen sink base very sturdy so I did).