Felt and Wire Angel Ornament


This darling little angel is cute on the tree and makes a nice package topper. Make them in all the colors of felt you can find!



Author's Blog:

Step by Step Instructions

  • Step 1

    Using the pattern, cut two of each piece from felt.

    Add a knot for each eye on one of the head pieces. Sew each piece to its mate near the edge using embroidery thread.

  • Step 2

    Fold the wire in half and twist about 1″ from the fold to create a loop.

  • Step 3

    Pull the two ends of the wire together and slide the head over the top with the wire inside.

  • Step 4

    Slide the body on using the same method and push it up next to the head. You can add a dab of glue between the two to keep the angel from sliding down later.

  • Step 5

    Curl the feet up about 1″ from the wire ends using a pair of needle nosed pliers.

  • Step 6

    Using hot glue, attach the wings to the back, gluing them to both the head and body.

  • Step 7

    All that’s left is to hang her up or give her away!

Leave a Reply

Your email address will not be published. Required fields are marked *