I had seen pumpkins similar to these a while back and wanted to make them for the longest time, I finally did it this year! This project was incredibly easy and fast. It took me less than an hour. The only cost inquired for this project was the twine wire at my local craft store as I already had the pumpkins on hand.
Grapevine Pumpkins
Inspired From:
You Will Need...
- Pumpkins
- Twine Wire
- Hot Glue
- Wire cutters
Step by Step Instructions
Step 1
Measure the lengths of twine wire to go from the bottom of the pumpkin to the stem, form the wire to the pumpkin as you do this and then cut the lengths you will need for each indent (I skipped a few indents as I wanted my wire evenly separated).
Step 2
Insert the wire into the bottom of the pumpkin and use hot glue on a few pieces of wire near the stem just to make it easier for you to grab all the pieces up by the stem.
Step 3
wrap a small piece of wire around all the lose ends around the stemp
Gallery
Hey Laura,
These are fantastic! Thank you so much for taking the time to share them on your Tip Junkie craft room.
Just a heads up, Tip Junkie can help you index your blog posts better if you change your INSPIRED BY link to the same TITLE as your blog post. This proves to Google {and other search engines} that your article is legit as well as what your post is about. It does other fancy stuff like increases your keyword, tag, and meta strength… to get a bit techy. Hope this helps! Laurie {a.k.a. the Tip Junkie}