Thanksgiving Utensil Holder {free printable}

Step One:

Click over to my Thanksgiving Silverware Pocket to download the free printable file.

I prefer LD Premium Inkjet Heavy Coated Paper it’s inexpensive and prints in vivid colors.

Step Two:
Before printing make sure that the “fit to page” selection “Is NOT” selected so they print out the correct size.

Step Three:
Load your printer with your cardstock or matte photo paper and print the pocket template.

Step Four:
With a good pair of paper scissors cut the template and inside top lining out from the printed sheet.

Step Five:
Create folds on the grey lines printed on the front of the utensil holder. See attached photo on where to apply the double sided tape.

I prefer Scor-Pal double sided tape or ribbon to attach gift tags to your packages.

Step Six:
Remove the tape from the inside lining topper and place it along the top and sides of the inside (blank side)of your pocket. If you are off a little on the alignment just trim along the top edges so they both match up.

Fold the right side flap over to match the seam line on the left center. This side does not require any tape.

Then fold the left side (with tape) over to match the outer edge on the right. Press firmly to adhere the tape.

Step Seven:
Run double sided tape along the bottom flap. Fold the flap up and press to seal.

Your silverware pocket is complete now and ready for you to place a folded napkin and silverware into it.