Travel Clippie Case Tutorial

Cut (1) 6 ½” x 8 ½” exterior fabric
Cut (1) 6 ½” x 8 ½” interior fabric
Cut (2) 6 ¼” x 8 ¼” fusible fleece (one for interior and exterior pieces)
Cut (2) 4” x 4” pieces of fabric which will be your flap
Cut (2) 3 ¾” x 3 ¾” pieces fusible fleece
Cut (1) 6 ½” x 8 ½” medium weight interfacing
Cut (2) 7” ric rac

Iron fusible fleece on to the backside of both of your flap pieces (4” x 4” pieces).

Place them right sides together and sew where indicated.

Clip corners and then turn inside out. Press and then topstitch as shown in pic.

Place one of your 3” pieces of Velcro about ½” down from the top of the flap on the interior side. Sew in place and then set your flap aside.

Place ric rac on each end of interior piece 2” in as shown below. Pin down in the middle to hold in place. Make sure to keep the pins out of the seam allowance.

Now let’s make a sandwich. Place your interfacing down on your workspace. Then place your exterior case piece right side up. Then your flap piece with the Velcro facing up.

And finally, lay your interior case piece right side down. Pin in place.

Mark a 3” opening on the side of your case. Sew from one mark to the other back stitching at the beginning and end.

Clip corners. Then reach in and pull out the pins you used to secure the ric rac. Pull the inside out through the opening. I’m not going to lie, this part sucked!

Fold your case in half, letting the flap come over the top. While still holding the flap down, lift it enough to place your other piece of velcro where it needs to go. Pin the velcro in place.

Now, turn it over and flip the ric rac over and pin it out of the way like in the picture below.