Simple Flower Headband Tutorial!

First you will need to measure the circumference of your child’s head (or your head if you’re making one for yourself!) The length of ribbon that you’ll need will be about three inches less than the total circumference For example, if your daughter’s head measures to be 20 inches in circumference, you’ll need a 17 inch piece of ribbon.

Once you’ve cut your ribbon you will need to fold the ends over just barely and hot glue them, this way your ends won’t be visible and there won’t be any fraying. The picture below shows what the ribbon will look like with the edge folded over and glued down.

Next you are going to cut your elastic. You want the elastic to be three inches in length to make up for the difference in the length of the ribbon.

Once your elastic is cut, glue it onto each end of the ribbon, creating a circle.

For the flower, cut a strip of felt that is about 1 inch wide and 12 inches long. (You can really get creative here and make longer or shorter ones that vary in width so that you get a few different sizes)

Fold your felt in half and make tiny cuts along the entire length. You can either make your cuts along the open side as seen in the picture below, or along the closed side. Both result in cute flowers that look slightly different.

Finally you’re going to roll your strip of felt up, hot gluing ever so often to make sure it stays in place.

When you reach the end, hot glue the end piece so that it stays in place and then glue your flower onto your headband. Below is the end result.